Kodak Instamatic M Series, Ремонт

Страница: 18 / 56

16/KODAK M-SERIES PROJECTORS
loosen the screw and swing aside the spring clamp, Fig.
D51). As you'll see on reassembly, you can then simply seat
the bearing over the end of the shutter-drive shaft—
after
you've installed the shutter-drive shaft in the mechanism.
That's a lot easier than trying to thread the shutter-drive shaft
through the bearing hole.
Now, with both the in-and-out cam and the shutter removed,
you can perform practically all of the repairs you'll be
making on this projector. There's rarely a reason to remove
the claw assembly, Fig. D50. However, we've removed the
claw assembly in Fig. D53 just to show the ball bearings.
Remember, if you lift the claw arms too far, the ball bearings
can fall out.
You can lubricate the ball bearings without removing the
claw assembly. Use your oil syringe to lubricate the tracks in
which the balls ride, Fig. D54.
SHUTTER-SIDE BEARING FOR SHUTTER-DRIVE SHAFT
SHUTTER-SIDE
BEARING FOR
SHUTTER-DRIVE
SHAFT
CLAW ASSEMBLY
CAM FOLLOWER
FIG. D52 Cam follower removed from the claw
assembly. The cams on the shutter-drive shaft
ride against this follower to provide the up-
and-down claw movement.
SHUTTER REPAIRS & INSTALLATION
As mentioned earlier, the plastic shutter gear can break or
deteriorate. Then, since the shutter drives the in-and-out
FIG. D50 Parts of the shutter removed from the mechanism.
SHUTTER-DRIVE SHAFT
SPRING
SHUTTER
WASHER
FIG. D51
Compliments of:
www.KodakParts.com