Kodak Instamatic M Series, Ремонт

Страница: 21 / 56

19/KODAK M-SERIES PROJECTORS
Make sure that the two cam followers are seated on the
claws, Fig. D52. Then seat the shutter-drive shaft. Remember
the position of the up-and-down cams you noted during
disassembly—parallel to the cam followers, Fig. D61. For
reassembly, start with the larger cam at around a 45° angle as
indicated by the dashed line in Fig. D61. Then, as you seat
the shutter-drive shaft, turn the shutter-drive shaft clockwise
until the cams are horizontal, Fig. D61. The shutter-drive
shaft should now seat fully.
V ARIATION:
Seating a shutter-drive shaft that just has
one cam is a little easier—the position of the cam isn't
critical. Pull down the claw assembly, Fig. D63, and insert
the shutter-drive shaft.
Hold up the shutter-drive shaft as shown in Fig. D62 as you
seat the parts at the other end. Fig. D64 shows the end of the
shutter drive shaft passing through the shutter—this is the
end that also passes through the shutter-side bearing. Use
your oil syringe to lubricate the end of the shutter-drive
shaft, Fig. D64.
PULL DOWN THIS SECTION OF THE CLAW
ASSEMBLY
FIG. D63 Variation—claw assembly in the M70
projector.
FIG. D61 Installation position for the M80
shutter-drive shaft—start with the large lobe
on the dashed line and then turn the shutter-
drive shaft clockwise to the position shown.
FIG. D62 Holding the shutter-drive shaft in
place to replace the parts at the front of the
shutter.
FIG. D64 Lubricate the front of the shutter-
drive shaft with shutter oil.
Compliments of:
www.KodakParts.com