Software Control of the PDA Detector 2800
19
•
Lamp off at the end of run: if lamp off is enabled the lamp(s) will
be switched off at the end of a run (default: disabled)
Fig. 19
Spectrometer Information
By clicking on Info and then on Info again, the Spectrometer Information
from the current detector will be loaded. The individual wavelength range
of this detector will now also be shown as Range in the Instrument Setup
(there is no information about what lamps are installed in the detector).
All parameters are saved together with the current method.
This has to
be done with every new method or if the detector is exchanged
.
Fig. 20
Select type of synchronization
In the Trigger menu the trigger can be chosen between None (immediate
start), Manual (start after confirming with Enter), External (Trigger must
be applied to a chosen instrument) or Wired (Trigger must be applied to
all instruments). (default: None)
Input defines the instrument which should be connected to the trigger.
