Kipp & Zonen SOLYS Gear Drive, Инструкция по эксплуатации

Страница: 77 / 112

4.5 Interfacing with thrid party applications
Creating script is possible to retrieve data from the SOLYS via the Ethernet port TCP/IP 15000. The SOLYS sun tracking application
has its communication interface on TCP port 15000. Note that it can only handle one connection at a time on this port. In case of
a new connection request, the existing socket is disconnected. Note that the web interface of the SOLYS also uses this TCP port
to control the sun tracking application. Therefore, do not use the web interface and direct communication to the TCP port at the
same time. Also, do not communicate directly with multiple applications to the TCP port. This may lead to unexpected behavior.
4.5.1 Error codes
If an unrecognized command or a command with missing or incorrect parameters is received, the tracker will respond NO
followed by one of the following error codes:
• 1 framing error
• 2 reserved for future use
• 3 unrecognized command
• 4 message too long
• 5 unimplemented instruction or non decodable parameters
• 6 motion queue is full, movement command rejected
• 7 travel bounds exceeded
• 8 maximum velocity exceeded
• 9 maximum acceleration exceeded
• A instrument is operating autonomously, command rejected
• B invalid adjustment size
• C invalid total adjustment
• D duration out of range
• E reserved for future use
• F illegal extent specified
• G attempt to change password protected data
• Y hardware failure detected
• Z illegal internal firmware state
77