Kipp & Zonen SOLYS Gear Drive, Инструкция по эксплуатации

Страница: 59 / 112

This section describes how to communicate with the SOLYS via Ethernet and how to download the LOG files from the SOLYS in
case of troubles.
Communication with the SOLYS is established via its network interface. However, the SOLYS is not protected by
an internal firewall and does not use password encryption. Therefore, the network connected must be secured
properly, to avoid hacking of the SOLYS.
The following steps are required to use the Ethernet port for communication with the SOLYS.
Check that all unused connectors on the bottom of the SOLYS have their caps installed during normal operation. The Ethernet
connection has a loose gray cap. Both power connections and the sun sensor have attached caps that should be closed when not
in use.
4.1 Ethernet connection
1. Download and install Safari for windows from support.apple.com/downloads/safari
2. Remove the plastic plug from the Ethernet connector
Figure 4.1 Ethernet connector
The Ethernet connector is fitted with a plastic plug (screw cap) to make it waterproof. If this cap is removed a RJ-45 connector can
be fitted. The cable is ideally of the Cat 5e type and should be shielded. To make the connection waterproof the supplied cable
gland for the connector should be fitted to seal the connector against water ingress.
4. Ethernet communication and configuration
Ethernet connector
Remove plastic plug
59