KIPI ROT-POWER 10-50 kW, Руководство по обслуживанию

Страница: 17 / 46

17
Operating modes Description
FIRING Automatic firing-up of the furnace.
OPERATION The burner operates with nominal power. Fuel is supplied automati-
cally.
CONTROL The burner operates at low power to keep the furnace burning. This
mode is activated automatically after the pre-set parameters are
achieved. The default time for this mode is 30 minutes.
DAMPING This mode is used for damping (extinguishing) the burning of fuel
residue.
STAND-BY In this mode, the boiler and burner are off. The stand-by mode is
automatically terminated after receiving the restart signal (e.g. tem-
perature drop on the boiler).
The first step includes activation of the fan, which initially blows-through the combus-
tion chamber. Then the fuel feeder is activated to dose fuel needed to fire up the furnace. Af-
ter the fuel is dosed, the igniter is activated to ignite the supplied fuel. Firing time may vary,
as it depends on the fuel type It usually takes 1-3 min. The display shows message "FIRING".
When the supplied dose of the fuel lights up - i.e. the value of the parameter measured by the
photodetector reaches the pre-set value - the firing mode ends and the burner will enter the
automatic operation mode - the display will show "OPERATION" message. when the light
intensity inside the combustion chamber drops, i.e. the furnace is quenched - the burner will
restart the firing mode. After reaching the limit parameters (i.e. boiler temperature, the tem-
perature set at the room thermostat), the controller enters "CONTROL" mode and then the
mode which depends on current indications of sensors, as described in the table.
Burner operation is prohibited when the rotation of the combustion chamber is disa-
bled.