KIPI ROT-POWER 10-50 kW, Руководство по обслуживанию

Страница: 19 / 46

19
boiler manual
Boiler critical temperature
is exceeded (95
O
C) – STB
sensor triggered
You must determine the cause
of this error.
Clear the error by pressing the
button on the controller housing
5. Alarm:
"Boiler tempera-
ture sensor dam-
aged" Boiler temperature sensor
damaged
Contact the customer service of
the Manufacturer
6. The fan does not
stop
after the
burner is
quenched
Photodiode damaged or
dirty
Clean the photodiode
In case of damage, contact the
customer service of the Manu-
facturer
7. The burner is
smoking
The amount of air fed into
the combustion chamber is
too low
Clean the furnace
The air inlet to the burner is
covered/obstructed
Clean the burner air inlet locat-
ed in the bottom part of the
burner
The fan is damaged
Contact the customer service of
the Manufacturer
8. Too much slag in
the furnace Incorrect fuel type
Use fuel recommended by the
manufacturer
The rotating drive of the
combustion
chamber is
damaged
Contact the customer service of
the Manufacturer
Any maintenance work requiring changes in the burner or auger feeder must be carried
out after disconnecting the burner from the power supply and cooling down the burner.
9. Maintenance, adjustment and servicing the burner.
Maintenance must be strictly performed on cooled down burner disconnected from the
power source.
9.1. General guidelines.
In order to ensure trouble-free operation, as well as to extend the life of the burner, the
following steps should be applied:
1. The hearth should be kept clean - through its regular cleaning. The frequency of clean-
ing depends on the quality of the fuel, its ash content and humidity, as well as the