KIP 7170K, Руководство по обслуживанию

Страница: 507 / 865

K134sm7e1 7-5
7. 1. 1. 4 Registration Sensor “Delay”, “Stay”, “Early”, “Remained”
Registration Part Jam (J-00000200)
Cause Checking
order
Checking Result Treatment
Mis-feed of paper 1 Does the paper mis-fed occur around the
Registration Roller?
Yes Remove the mis-fed paper.
Registration
Sensor (PH1)
2 Check the status of Registration Sensor
in Input Check of the Service Mode.
Signal Code :
00100 REGIST-S (Registration Sensor)
Is the status “L” when the paper is not
passing beside the sensor?
And is it “H” when the paper is passing
beside the sensor?
No 1. Check if there is any
problem with the wire
connected to the
Registration Sensor.
2. Replace the Registration
Sensor if there is no
problem with the wire.
Engine Unit 3 Is the Engine Unit closed firmly until it is
locked?
(Is the pressure around the Registration
Roller correct?)
No 1. Close the Engine Unit
firmly.
2. Adjust the pressure
around the Registration
Roller.
Driving mechanism 4 Check the operation of Registration
Clutch in Output Check of the Service
Mode.
Device Code :
00011 REG.-CL (Registration Clutch)
Also open and close the Roll Deck, and
check if the Main Motor rotates correctly.
Does each Registration Clutch and Main
Motor operate correctly?
No Replace the Registration
Clutch or Main Motor if it is
defective.
7. 1. 1. 5 Separation Sensor “Delay”, “Stay”, “Early”, “Remained”
Registration Part Jam (J-00000200)
Cause Checking
order
Checking Result Treatment
Mis-feed of paper 1 Does the paper mis-fed occur around the
separation area?
Yes Remove the mis-fed paper.
Separation Sensor
(PH2)
2 Check the status of Separation Sensor in
Input Check of the Service Mode.
Signal Code :
00010 SEP-S (STRIP_S) (Separation
Sensor)
Is the status “L” when the paper is not
passing beside the sensor?
And is it “H” when the paper is passing
beside the sensor?
No 1. Check if there is any
problem with the wire
connected to the
Separation Sensor.
2. Replace the Separation
Sensor if there is no
problem with the wire.
Transfer /
Separation Corona
3 Is the Transfer / Separation Corona Unit
installed to the machine correctly?
Yes Install the Transfer /
Separation Corona Unit
correctly.
Is the Corona Wire broken? Yes Replace the Corona Wire.
HV Power Supply 4 Is the output from the HV Power Supply
to the Separation Corona correct?
No Replace the HV Power
Supply.