KIP 7170K, Руководство по обслуживанию

Страница: 710 / 865

K134sm8e6 8-151
8. 4. 3. 121 Fuser Motor Speed applied at 100mm from trailing edge
(36” / 34” / 30” / A0 / B1 width) (No.743 to 745)
It is possible to adjust the speed of Fuser Motor driving on 100mm end of a print in 36” / 34” / 30” /
A0 / B1 width.
This setting may be a solution for image void on the trailing center.
If you increase the setting value by “+1”, speed of Fuser Motor driving becomes 0.04mm/s slower
than the applied speed at that point.
Item
No.
Setting Item Default value Setting
range
Step of
increment
USA EUR/AS CN CND
743 Fuser Motor Speed applied at 100mm from trailing
edge (36” / 34” / 30” / A0 / B1 width) (Plain)
0 1 1 1 0 to 80 0.04mm/s
744 Fuser Motor Speed applied at 100mm from trailing
edge (36” / 34” / 30” / A0 / B1 width) (Tracing)
0 15 15 15 0 to 80 0.04mm/s
745 Fuser Motor Speed applied at 100mm from trailing
edge (36” / 34” / 30” / A0 / B1 width) (Film)
0 0 0 0 0 to 80 0.04mm/s
8. 4. 3. 122 Roll 2 Forward Standby ON/OFF (No.746)
The default Standby Position for the leading edge of Roll 2 is located directly below the set sensor
(PH9). This setting will feed the leading edge to Forward Standby Position (approximately 252mm
forward from the default Standby Position).
Default value Setting value Contents
0 0 Roll 2 Leading Edge stays at the set sensor
1 Roll 2 Leading Edge goes Forward Standby Position
8. 4. 3. 123 Roll 2 Forward Standby Position Adjustment (No.747)
This setting can adjust Roll 2 Forward Standby Position (approximately 202 to 252mm forward
from the default Roll 2 Standby Position) with Roll 2 Forward Standby on. When the setting value
increases by 1, Roll 2 Forward Standby Position will shift backward to the default Standby Position
in 1mm. (“0” for 252mm forward, “50” for 202mm forward)
Default Value Setting Range Step of increment
0 0 to 50 1mm
8. 4. 3. 124 Roll 2 Rewind Timer (No. 748)
This setting can work as a timer to rewind Roll 2 media from Forward Standby Position to the
default Standby Position with Roll 2 Forward Standby on. When the setting value decreases by 1,
the interval of rewinding Roll 2 media to the default Standby Position becomes 1 minute shorter.
When the setting value is "0", the roll media is not rewound.
Default Value Setting Range Step of increment
15 0 to 15 1 min