KIP 7170K, Руководство по обслуживанию

Страница: 19 / 865

K134sm2e2 2-1
2. 1 Installation Requirements
The following conditions are required for the installation of the equipment.
1. Power source should be rated as:
U.S.A: 120V +/-10%, 50/60Hz, 15A or higher
Europe and Asia: 220-240V+6% or -10%, 50/60Hz, 10A or higher
2. The equipment must be on a dedicated circuit.
3. The outlet must be near the equipment and easily accessible.
1. Make sure to connect this equipment to a properly grounded outlet.
2. The outlet shall be installed near the equipment and shall be easily accessible.
Site Environmental Conditions
Temperature Range
10 C to 32 C
50 F to 89.6 F
Humidity Range
15% to 85% RH. (NON CONDENSING)
Keep the printer away from water sources, boilers, humidifiers, refrigerators or kerosene (oil) stove.
1. The installation site must not have any open flames, dust or ammonia gases.
2. The equipment must not be exposed to the air vents from heating/cooling systems.
3. The equipment should not be exposed to the direct sunlight. Please draw curtains to block any sunlight.
When you open the printer (Upper Half), do not expose the Photoconductive Drum to strong (intense) light as this will
damage the Drum.
Ozone will be generated while this equipment is in use, although the quantity generated is within all safe levels.
(see certifications)
Ventilate the room, if so required.
Keep ample space around the equipment to ensure comfortable operation.
(Refer to the following figure.) The floor must be level and the strength must be ample to sustain the weight of the equipment.
*L+R=35cm/14” or larger
(R must be larger than L)
(L=5cm/2” or larger recommended)
L* R*
(Rear)
(Front)
30cm/12” or larger
80cm/32” or larger for Roll Deck
90cm/35.4” or larger
for Paper Tray (option)
KIP 7170