KIP 7170K, Руководство по обслуживанию

Страница: 513 / 865

K134sm7e1 7-11
Error Code Error Indication Conditions
E-0335h
/E-821
Process 1 Density Sensor Error The default output of Density Sensor
reaches less than 0.1V or more than
1.3V.
E-0336h
/E-822
Process 1 Density Compensation
Error
The gap between the default output and
the standard output of Density Sensor
reaches less than 2V.
E-0800h
/E-2048
Counter-A Error The Counter Connection Detection Signal
(COUNT_OPN) continues to be “L” for 1
second or longer after turning on.
E-0900h
/E-2304
Fuser Low-Temp Error 1. Fuser Temperature at the time of
turning on was 50 to 100
o
C, but it
does not rise up to 120
o
C within 150
seconds after that.
2. Fuser Temperature at the time of
turning on was higher than 100
o
C, but
it does not rise up to the setting
temperature within 330 seconds after
that.
The difference of temperature between
center and side of fuser becomes 50
o
C or
more.
The Lamp of fuser lights (Signal HEAT1
is “H”) to heat up the Fuser Roller in the
ready condition, but even 1
o
C of
temperature rise can not be
accomplished within 30 seconds.
E-0901h
/E-2305
Fuser Over-Temp Error Fuser Temperature reaches over 230
o
C.
E-0903h
/E-2307
Fuser Thermostat Error Fuser Temperature does not reach 50
o
C
within 120 seconds after turning on.
E-0920h/E-
2336
Fuser Motor Error The Fuser Motor Output Detection Signal
(HEATM_LD) continues to be “H” for 3
seconds or longer when the Fuser Motor
is rotating.
E-0A00h
/E-2560
Backup Data Write Error Access to f-ram is failed.
E-0A20h
/E-2592
Main Board Error Initialization of FPGA is failed after
turning on.
E-0A41h
/E-2625
KNC1 Error The information in IC Tag does not
correctly match such information as
“model” and “regional setting”.