KIP 7170K, Руководство по обслуживанию

Страница: 640 / 865

K134sm8e6 8-81
“Paper creasing” or “image void” on a long print may be removed by Fuser Motor Speed
compensation.
Long Print without Fuser Motor Speed compensation
Leading edge
Image Void Paper Creasing
Fuser Motor Speed, Fuser Motor 1/2/3/4 Speed correspond to the area shown as follows.
To remove “paper creasing” or “image void”, adjust Fuser Motor 3rd/4th Speed according to the
situation.
0
100
50
A
B
C
Standard Length
0
100
50
A
B
C
Reference
NOTE
(1) When “Switching Timing” is set to 0, the subsequent Fuser Motor Speed settings are not
applied.
4th Speed is not used when Fuser Motor 4th Speed Switch Timing is set to “0”.
3rd/4th Speed is not used when Fuser Motor 3rd Speed Switch Timing is set to “0”.
(2) Fuser Motor 3rd/4th Speed are factory-adjusted for the following media width as follows.
3rd Speed 4th Speed
plain all width all width
tracing/vellum all width
A0/36”/34”/30”
less than above: not used
film not used not used
cutsheet
(except film)
factory-adjusted not used
“not used” means that the previous Switch Timing is set to “0” because the corresponding
print area exceeds the guaranteed length.
Fuser Motor
Speed
Fuser Motor
1st Speed
Fuser Motor
2nd Speed
Fuser Motor
3rd Speed
Fuser Motor
4th Speed
1st Speed
Switch Timing
2nd Speed
Switch Timing
3rd Speed
Switch Timing
4th Speed
Switch Timing