Kia 1U056 ADU00, Руководство по установке

Страница: 21 / 25

Revision Date
4/22/2013
Page 21 of 25
Vehicle’s parking lights do not
fl ash.
Poor operating range.
*Verify that the 24-pin male and female I/P-D
connectors are connected properly (Step 19).
*Verify that the fuses located under the DNA case top
labeled “PK LIGHTS” and “DR DOOR/TRNK REL” are
good and installed properly per the Fuse and Jumper
diagram in Troubleshooting.
*Verify proper DNA installation into module.
Issue / Concern Items To Be Checked
Instruction Ref.
Step 17
Instruction Ref.
Step 17
Instruction Ref.
Steps 9, 10,
12 & 17
*Verify that the 26-pin male and female I/P-L
connectors are connected properly (Step 17).
*Verify proper DNA installation into module.
KIA Genuine Accessories
Troubleshooting
Vehicle’s burglar horn does not
honk when activating the car fi nd
or the panic feature.
Vehicle will not automatically lock all
doors after remote start activation. *Verify that the 6-pin male and female Key-In-Sense
connectors are connected properly (Step 15).
*Verify that the 26-pin male and female I/P-K
connectors are connected properly (Step 20).
*Verify that the fuse located under the DNA case
top labeled “DOOR LOCKS” is good and installed
properly per the Fuse and Jumper diagram in
Troubleshooting.
*Verify proper DNA installation into module.
Instruction Ref.
Steps 15 & 20
*Verify that the antenna is mounted in the correct
location (Steps 9 & 10).
*Verify that the antenna cable connector is plugged
into the back of the remote start module (Step 12) and
that the antenna cable is NOT shorted along it’s entire
path.
*Verify that the remote start harness ground wire was
connected properly (Step 17).
*Refer to Page 23 for Transmitter Programming an
Battery Test Procedure.
Instruction Ref.
Step 17
Vehicle will not unlock all doors
using the transmitter during the
remote start mode.
*Verify that the 26-pin male and female I/P-L
connectors are connected properly (Step 17).
Vehicle will not unlock the driver’s
door using the transmitter during
the remote start mode.
Instruction Ref.
Step 20
*Verify that the 26-pin male and female I/P-K
connectors are connected properly (Step 20).
*Verify that the fuse located under the DNA case
top labeled “DOOR LOCKS” is good and installed
properly per the Fuse and Jumper diagram in
Troubleshooting.
*Verify proper DNA installation into module.
Vehicle’s dome lights do not turn
on during the remote start mode.
*Verify that the 26-pin male and female I/P-L
connectors are connected properly (Step 17).
*Verify interior lamp switch is set to
door
position.
*Verify that the fuse located under the DNA case top
labeled “DOME LIGHT” is good and installed properly
per the Fuse and Jumper diagram in Troubleshooting.
*Verify proper DNA installation into module.
Instruction Ref.
Step 19