Kia 1U056 ADU00, Руководство по установке

Страница: 7 / 25

Revision Date
4/22/2013
Page 7 of 25
1. Use four (4) small wire ties to secure the antenna cable to the factory harness located within the “A” pillar, as
shown above. Trim off excess wire ties.
Wire Cutter
11
N
O
T
E
!
KIA Genuine Accessories
Small Wire Ties
Antenna Cable
Air Bag Infl ator
WARNING! Air Bag system interference hazard. DO NOT wrap antenna cable around or secure antenna
cable to any Air Bag components. Damage to the vehicle’s Air Bag system may occur which could result
in serious physical injury.
CAUTION! Ensure the antenna cable is routed away from the Air Bag In fl ator.
CAUTION! If the vehicle is equipped with a sunroof, be careful not to place the wire ties around the drain
tube or the sunroof may not drain properly.
12
CAUTION! Be careful not to bend/damage any of the terminals inside the remote start module.
Antenna Cable
Connector
N
O
T
E
10-Pin
24-Pin
16-Pin
1. Remove the two (2) transmitters and attach individually to each factory key.
2. Route the antenna cable past the left side of the dashboard and over to the dash wall area.
3. Plug the remote start harness 16-pin connector, 24-pin connector, 10-pin connector and the 2-pin antenna cable
connector into the remote start control module before mounting.
4. Ensure all connectors are properly locked into position.