Kia 1U056 ADU00, Руководство по установке

Страница: 9 / 25

Revision Date
4/22/2013
Page 9 of 25
1. Route the remote start harness 6-pin male and female key-in-sense connectors along the right side of the
steering column to the factory M37 key-in-sense connector.
2. Disconnect the factory female 6-pin M37 key-in-sense connector and plug in the corresponding remote start
harness
connectors.
3. Secure the factory female M37 key-in-sense connector and the remote start harness male key-in-sense
connectors to the factory male M37 key-in-sense connector with one (1) small wire tie, as shown above. Trim off
excess wire tie.
1. Route the remote start harness 6-pin male and female ignition connectors along the factory harness up to the
factory M15 ignition switch connector.
2. Disconnect the factory female 6-pin M15 ignition switch connector and plug in the corresponding remote start
harness
connectors.
14
N
O
T
E
15
N
O
T
E
WARNING! Engine Stall Hazard. To prevent stress on the remote start wire harness, ensure the tilt/
telescopic steering column is fully extended, if equipped. Ensure all connectors are fully engaged and
locked in place. An engine stall could cause serious physical injury or vehicle damage.
!
Tilt Steering Wheel Release Lever
6-Pin Female Harness Connector
Factory Female M15
Connector
6-Pin Female
Harness Connector
6-Pin Male Harness Connector
KIA Genuine Accessories
Wire Cutter
Small Wire Tie
Factory Female M37
Connector
6-Pin Male Harness Connector
Factory Male
M37 Connector