Programming
3
Keysight 53147A/148A/149A Operating and Programming Guide
151
Programming the Instrument for Remote Operation
This section provides remote-operation setup and programming information. You
can use this information to configure the instrument to operate as a remote
device.
NOTE
Most of this chapter deals with programming the Keysight 53147A, 53148A, and
53149A using SCPI and IEEE 488.2 commands. With two minor exceptions, the
only difference between programming these instruments using the GPIB
interface and the RS-232 serial interface is the manner in which you connect the
instrument to the computer. These exceptions are:
1
The instrument sends a command prompt over the RS-232 interface
(but not the GPIB) after receiving and executing each command.
2
When an error is detected (during the Self-Test or during operation),
the instrument automatically sends an error message (or messages)
over the RS-232 interface (error messages must be requested over the
GPIB). For additional information on error messages, see Appendix B.
Содержание 53147A
Страница 1: ...Keysight 53147A 148A 149A Microwave Frequency Counter Power Meter DVM Operating and Programming Guide ...
Страница 20: ...20 Keysight 53147A 148A 149A Operating and Programming Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...
Страница 310: ...312 Keysight 53147A 148A 149A Operating and Programming Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...