Ketterer KuLi Series, Руководство по сборке

Страница: 42 / 44

Self-help and diagnosis in case of malfunction
3215.72-01i01 Rev. A
P a g e | 38
Preparatory activities for maintenance:
 Maintenance work may only be performed by qualified
personnel. Qualified personnel are persons with appropriate
specialized training and experience who understand the
construction requirements, the design of the KuLi and the safety
regulations.
 Set the KuLi out of operation before maintenance.
Action Maintenance intervals Notes
Check KuLi for external damage Daily before operation Visual inspection
Check for blockage of the
movement path
Daily before operation Visual inspection
Check screws for fastening on
torque
Every 6 months Torque depends on the used
screw
Tight fit of the screwed
connection cables
Every 6 months Hand-tighten
Lubrication
No action necessary All motor components are
lifetime lubricated
11 Self-help and diagnosis in case of malfunction
You can correct malfunctions of the device by observing the
following table.
Malfunctions that cannot be corrected according to this table
or damage to the device must be reported immediately to the
qualified personnel responsible for the electrical connection.
Malfunction Possible cause Solution
No connection to the KuLi
KuLi is not connected Connect KuLi
USB connector is not connected Connect USB plug
Connection to PLC is not plugged in Establish connection
LEDs do not light up
PLC is powerless Switch on power supply
USB plug is not connected Connect USB plug