Ketterer KuLi Series, Руководство по сборке

Страница: 23 / 44

Assembly
3215.72-01i01 Rev. A
P a g e | 19
5.1.1 Fixing the KuLi in the application
Fix the KuLi in your application using the 4x M6 (12 mm deep)
mounting holes on the back. Use screws of a suitable length for
your application. Tighten them with a torque according to the
manufacturer's specifications of the screws.
The KuLi has centering countersinks (Ø9 f9) for corresponding
centering sleeves in these mounting holes to achieve optimum
alignment of the KuLi.
The illustration shows a mounting example. The centering
sleeves, shown in green, are not included in the scope of
delivery.
Note:
The KuLi also has additional holes on the side and top which can
be used for mounting. Be sure to observe the smaller diameter
of M4 and use screws suitable for your application. The
maximum tightening torque is 2.5 Nm.
5.1.2 Connection to the lifting plate
The KuLi is equipped with a lifting plate, which is provided with mounting holes
2x M4 (10 mm deep) and holes for alignment pins 2x Ø4 (10 mm deep). Use
only these fastening points to connect the load. Use screws of a suitable length
for your application. Tighten them with a torque according to the
manufacturer's specifications of the screws. Observe the maximum torque of
2.5 Nm for the housing.