Kessel Ecolift, Инструкции по установке, эксплуатации и техническому обслуживанию

Страница: 39 / 144

Installation
39 / 144 04/2017
3.9 Connecting the venting pipe (optional)
The venting pipe (optional) must be routed in such a way that it
does not hinder access for maintenance purposes nor the other
pipe connections (pressure pipe / cable conduit pipe).
- Screw the venting valve <11> out of the pump unit
<20>.
- Fix the vent pipe to the connection <12> on the venting valve
and route it through the drain body above the sealing
level.
3.10 Preparing the connection of the pressure pipe
- Remove the sealing plug <21> on the drain body <1>.
- Insert sealing gasket <24>
- Fit the connecting piece <22> from the inside of the tank on
the extension section <1> and tighten the nut <23>
using approx. 10 Nm.
- Connect the on-site pressure pipe to the connecting piece.
11
20
12
Fig. [15]
1 22 23
21
24
Fig. [16]
3.11 Only for installation in an exposed drainage pipe
- Fit a connection piece <80> between the pump connection
muff <18> and connection piece <22>,
and lock both the red quick-release closures <25>.
3.12 Installing the cable conduit
- Bring the cable conduit (DN70) up to the cable duct <41>
(DN50) on the drain body and fit it.
- For changes of direction use max. 45° bends.
Provide a cable tube for later retrofitting. If this cable tube has to
be installed in the upper section, drill a hole with the KESSEL
hole saw (article number 50101) or a standard Ø 60 mm hole saw
and put in the pipe sealing gasket (article number 850114).
18 80
22
25
Fig. [17]
DN50
DN70
41
Fig. [18]