Kerbl CowCleaner 18700, Руководство по эксплуатации

Страница: 45 / 196

45
6.3.1 Monitoring the brush resistance
The unit monitors the current used by the motor and therefore checks the correct functioning of the cattle brush. If the gear motor is placed under
too much strain, the brushes stand still and then move in the opposite direction. This can occur if the animals lean to far too one side or if a tail
gets wound up in the mechanism.
If this event is repeated several times without the unit having run properly in between, the unit first goes into an alarm state for a few minutes
and does not start during this time. If the load on the motor is not lower even after this pause, then the fault message "A03" is triggered after
further load cut-offs and the unit no longer starts.
The cut-off resistance can be set using the dip switch element (see table under 6.3.2) on the PCB. The cut-off resistance is lowest at the F1 setting
and highest at F15.
The default setting and therefore the best setting for the Cow Cleaning Machine HAPPYCOW Uno is T3.
6.3.2 Setting the cycle time
The cycle time is set at the factory to 60 seconds. If necessary, this can be adjusted using the dip switch element on the circuit board (Fig. 7 - item
1) to a value between 10 and 300 seconds. The cycle time may only be reset following consultation with Kerbl. The default setting and therefore
the ideal setting for the Cow Cleaning Machine HAPPYCOW Uno is T3.
6.3.3 Dip switch setting
Below is the default setting of the dip switch element on the PCB for this unit.
Once the unit has been restarted (connected to the power supply), the dip switch changes will take effect and the settings will be briefly shown
on the display.
Figure 8: Circuit board in control unit housing (capacitor behind the circuit board)