Kenwood NX-1200 D K2, Справочник по функциям

Страница: 111 / 132

5 ANALOG function
111
FleetSync Burst Noise Reduction
Type
‘ ■
Standard model
■
Basic model
Description
FleetSync Burst Noise Reduction mutes the incoming data burst tones when the transceiver receives
FleetSync data.
When the transceiver receives an MSK data burst tone, the transceiver evaluates whether or not the tone is
FleetSync data.
If it is FleetSync data, the transceiver mutes until it completes receiving FleetSync data. However, since it takes
a short period of time to recognize a tone as FleetSync data, the beginning of the tone may sound from the
speaker for a moment.
Timing to Activate the FleetSync Burst Noise Reduction
To receive the FleetSync data using BOT, the tone burst noise can be muted completely by configuring Mute
Hold Time to function at the same time. However, since
Mute Hold Time is valid for all communications, if the
time is configured overly long, the beginning of the voice signal may also be muted on a channel that does not
use the FleetSync functions.
Timing to Activate Mute Hold Time
Operating the transceiver - -
Note

FleetSync Burst Noise Reduction is valid only for MSK data in FleetSync.
Configuration using FPU
FleetSync Burst Noise Reduction : Edit > FleetSync > General 1
Mute Hold Time : Edit > Optional Features > Optional Features 1 > Common 1
FleetSync - GPS
Type
‘
■
Standard model
■
Basic model
Description Fleet and ID (GPS Base Station) is the FleetSync ID of the target transceiver used for sending GPS data.
By using KPG-D6/ D6N. The FleetSync ID of the base station which is responsible for operation and
administration of system is normally configured.
Operating the transceiver - -
Note

This function can be configured if "GPS" is selected from Function for COM port 0 .
Configuration using FPU Fleet , ID : Edit > FleetSync > GPS > Base Station