5
ENGLISH
Installation Instructions
Clearances and Dimensions
A. Provide adequate clearances between the range and adjacent combustible surface (1.3cm (1/2”) to the cabinet side
walls and the rear wall).
B. Location—Check location where the range will be installed. Check for proper electrical supply and the stability of
floor.
C. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be
solid and level.
Installation and service must be performed by a qualified technician.
IMPORTANT: Save for local electrical inspector’s use. Read and save these instructions for future reference.
45.7cm
(18”)
A
76.2cm (30”)
Minimum *
Minimum
to wall on
either side of
range.
91.4 cm
(36”)
B
SIDE
VIEW
FRONT
VIEW
Minimum to
cabinets on
either side of
range.
Maximum depth for
cabinets above
range top.
33cm
(13”)
1.3cm
(1/2”)
DIMENSIONS
A
B
76.2cm (30”)
78.7cm (31”)
A
66cm (26”)
91.4 ± 0.3cm
(36 ± 1/8”)
122cm (48”)
Maximum
114.3cm (45”)
Door Open
* 76.2cm (30”) minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or
metal cabinet; or 61cm (24”) minimum when bottom of wood or metal cabinet is protected by not less than 0.64cm (¼”)
flame retardant millboard covered with not less than 0.038cm (0.015”) stainless steel, 0.061cm (0.024”) aluminum or
0.051cm (0.020”) copper. 1.3cm (½”) clearance is minimum for the rear and sides of the range. Follow all dimensions
requirements provided above to prevent property damage, potential fire hazard, and incorrect countertop and cabinet
cuts.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a
range hood that projects horizontally a minimum of 12.7cm ( 5”) beyond the bottom of the cabinets.
Electrical Connection Requirements
Plug the range cable (4 conductors) into a 4 conductor range outlet. Outlet
must be properly grounded and in accordance with the Canadian Electrical
Code (CSA Standard (C22.1 Part 1 -- latest edition) -- and any local electrical
code requirements.
Location
Set your new range 1.3cm (½”) away from the rear wall and line it up with the kitchen counters. Make sure there is at
least 1.3cm (½”) of clearance between each side of the range and the kitchen counters. Allow 7.6cm (3”) min. clearance
between your range and the refrigerator, if they are side by side.