20
General Care & Cleaning
DO NOT
turn the oven light on
during the self-clean-
ing cycle. High tem-
perature will reduce
lamp life.
Changing the Surface Light
(some models)
Be sure all surface element control knobs are turned off and ele-
ments are cool.
Use switch located on or underneath the control panel to turn the surface light ON/
OFF.
Replace the surface light, if after repeated attempts to turn it on you are not successful.
To remove and replace the fluorescent light:
It is recommended to place a pocket mirror on the cooktop in middle at back. This will help you to
replace the fluorescent tube.
1. Place your fingers under the tube located underneath and in the middle of the control panel.
2. To remove, turn the tube 90° then pull it down and out of its sockets.
3. To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in
place. Turn on the surface light to make sure it will lit.
Oven Light
On some models an interior oven light will turn on automatically when the oven door is
opened.
The oven light may be turned on when the door is closed by using the oven light switch lo-
cated on or underneath the control panel.
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
BE SURE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb
and be sure to replace glass shield.
