KC-P30
Configuration
Installation manual V3.28
41
© KEBA
Get IP address via DHCP server - DSW2.1 to DSW2.4
DIP switch
Function
Illustration
DSW2.1
DSW2.2
DSW2.3
DSW2.4
By default, the charging process is carried out
independently by the charging station without a
higher-level control system.
The charging station attempts to obtain an IP
address via DHCP server, if needed. This also
corresponds to the basic settings for charging
stations without network connection.
Not valid for P30 x-series.
Set fixed IP address - DSW2.1 to DSW2.4
DIP switch
Function
Illustration
DSW2.1
DSW2.2
DSW2.3
DSW2.4
If there are several charging stations in a net-
work, an addressing of the charging stations is
necessary.
The last two digits of the IP address
(192.168.25.
xx
) can be specified with the DIP
switches DSW2.1 to DSW2.4. Each DIP switch
has a specific value when it is set to "ON". A
DIP switch set to "OFF" has the value 0.
DSW2.1
= ON = value:
1
DSW2.2
= ON = value:
2
DSW2.3
= ON = value:
4
DSW2.4
= ON = value:
8
The address is obtained by adding the values
of the DIP switches and increasing the result
by 10:
Sum of the DIP switch 10
Thus, the addresses
11 to 25
are settable.
Not valid for P30 x-series.
Example of IP address
xxx.xxx.xx.
21
DSW2.1
= ON =
1
DSW2.2
= ON =
2
DSW2.3
= OFF =
0
DSW2.4
= ON =
8
Address =
1
+
2
+
0
+
8
+ 10 =
21
Activation communication - DSW2.5
DIP switch
Function
Illustration
DSW2.5
Activation of communication in the charging
network.
This DIP switch setting must be made for each
master and slave charging station to enable
charging station communication.
Commissioning mode - DSW2.8
DIP switch
Function
Illustration
DSW2.8
Activate commissioning mode.
