KaVo ORTHOPANTOMOGRAPH OP 3D, Руководство пользователя и инструкция по установке

Страница: 55 / 117

9 Installation
• Do not install the device in environments where corrosive or explosive vapours or
flammable anaesthics are present.
• Special steps regarding EMC need to be taken when installing the device. For more
information, refer to the chapter Electromagnetic Compatibility (EMC) tables .
• The device is supplied with a 3m (10ft) long power cord. Ensure that when connected
to a power outlet, the power cord is long enough, taking in consideration the device's
up/down movements.
• It's recommended to use a max. 30 A circuit breaker with the device.
• Maximum allowed mains line impedance is 0.2 Ω.
• For permanent installation, a separate lockable mains switch (not supplied) is required
to be installed to the mains feed.
• Maximum mains over-current releases:
100-120V: 20A
220-240V: 16A
9.2.2 Space requirements
When you install the device, ensure that:
• There is enough space at the front and sides of the device to allow patients to enter
and exit the device easily. Patients in wheelchairs will require more space than
standing patients.
• There is enough space for the operator to position the patient correctly.
• The device is positioned at least 1.5m (59") away from any non-medical electrical or
electromechanical equipment.
• The device is positioned so that the operator who is protected from radiation can see
and hear the patient during the imaging, while maintaining visibility to the GUI.
• If the device is installed in an angle of 15 or more, the plywood supports may come
in the way of the installation and need to be removed. See more details in chapter
Device dimensions .
Absolute minimum installation space requirements
One man installation Two man installation
Depth 1800 mm / 70.9 in 1500 mm / 59 in
Width 1240 mm / 48.8 in 1500 mm /59 in
Height 2080 mm / 81.9 in
ORTHOPANTOMOGRAPH ™ OP 3D 55