KaVo FOCUS 215720, Руководство по установке

Страница: 13 / 63

3 Pre-installation
FOCUS 7
3 Pre-installation
3.1 Pre-installation checklist
Radiation protection:
Follow all local regulations for radiation shielding of
the X-ray room.
During the exposure the operator must follow
applicable radiation shielding requirements and
stay at least 7 feet (2 meters) from the radiation
source.
Mounting requirements:
The wall and mounting hardware must sustain a
pull of 350 lbs./1500N, from each wall bracket bolt.
When replacing an old X-ray unit using a wide wall
mount plate, observe the space that is covered by
the wall mount plate to minimize painting where
applicable.
Mounting on a treatment unit is allowed only when
the manufacturer of the treatment unit has tested
the mechanical stability and allow the integration.
For KaVo treatment unit integration refer the
compatibility table of the accessories available.
For OpenMount installation, the mounting shall
contain a bearing designed for a shaft of diameter
of 32 mm (h7) and a length of 105 mm when
mounting on a 3rd party adapter, to ensure that
the maximum load ratings of the adapter are not
exceeded by the FOCUS OpenMount unit. The
installation must provide tilt adjustment to level
and balance the arm. The installation must not
allow rotating the X-ray unit more than 360
degrees to prevent twisting of the cables.
Electrical requirements:
Mains voltage:
Verify the mains voltage (3 wire: single-phase, 115
V or 230 V with protective ground).
Fuses: