2 1 0
0
／
1
／
2
／
3
／
4
／
5
／
6
0
Thread slack electromagnet sequential selection:
0:211 parameter set point of [LS] after loose line, untilthe needle
position to delay 214 parameter set time [L2].
1:211 parameter set point of [LS] after loose line, until
the 212 parameter set angle [LE].
2:211 parameter set point of [LS]
after loose line, 214parameters set by the [L2] until the time delay.
3: bit signal delay [L1] set the time
to loose line, 214parameters set by the [L2] until the time delay.
4: needle position signal delay [L1] set the time
to looseline, 214 parameters set by the [L2] until the time delay.
Under 5: bit signal started loose line first stop pin stop.Then the
delay parameter 213 set time [L1] after
the 214parameter set loose line time [L2].
6: 211 parameter set point of [LS] after loose line, first stop pin
stop. Then the delay parameter 213 set time [L1] after the 214
Thread
slack/
Thread
sweeping/
String
nipping
Mode
2 1 1
5-359
25
Thread slack electromagnet start angle LS (relate to down needle
stop position angle)
2 1 2
10-359
350
Thread slack electromagnet finish angle LE (relate to down needle
stop position, the value should bigger than LS)
2 1 3
1-999
1
Thread slack electromagnet start time delay T1
（
ms
）
2 1 4
1
～
999
10
Thread slack electromagnet time delay T2
（
ms
）
after upper needle
stop position is reached
2 1 5
0
／
1
1
String sweeping function selection
0: off
1:on
2 1 6
1
～
999
10
Thread wiping/Thread sweeping time delay ms
20
