20
Connection and set-up
DiSEqC™ repeat:
The setting for how often the DiSEqC™
command must be repeated depends
on the con
fi
guration of your reception
system.
- Off
DiSEqC™ command is not repeated
- 1
DiSEqC™ command is repeated once
- 2
DiSEqC™ command is repeated twice
- 3
DiSEqC™ command is repeated three times
22 kHz control:
You only need to specify this data if your LNB type is “Simple”. The 22 kHz signal is needed to switch LNBs
when using multi-feed reception and to switch between Low and High band.
- On
- Off
Test Transponder:
Select the “Test Transponder”
fi
eld. Here you can select a transponder for checking whether your settings
are correct using the signal strength bar and signal quality bar.
When you have completed all settings for this satellite, press the
(green) button.
If you have selected more than one satellite (max. four) for Tuner 1, the receiver will automatically skip
to the settings for the second satellite. Now de
fi
ne the settings for the second satellite, followed by the
third and fourth satellites as required, in the same way as described for the
fi
rst satellite.
Once all settings for all the satellites that you selected have been completed, the receiver will
automatically skip to the settings for the second tuner (assuming that for the second tuner you selected
the connection type “Separated” and set the signal con
fi
guration to “Different from Tuner 1”). If this is the
case, now de
fi
ne the settings for the second tuner in the same way as you did for the
fi
rst tuner.
Once you have completed the settings for both tuners and the satellites assigned to them, the receiver
will automatically display the screen for the channel search. Continue the
fi
rst installation with the
“Channel Search” section.
Refer to the documentation for
your reception system or seek
assistance from a specialist
engineer.
