27
Move antenna:
Select the “Move Antenna”
fi
eld. Here you can control the movements of the polar antenna, using the
following buttons:
Start slow rotation to “West”
Rotate to “West” step by step
Stop the current movement
Rotate to “East” step by step
Start slow rotation to “East”
Set the turntable so that both of the bars “Signal strength” and “Signal quality” on the right of the screen
show the highest available percentage values.
Test Transponder:
Select the “Test Transponder”
fi
eld. Here you can select a transponder for checking whether your settings
are correct using the signal strength bar and signal quality bar.
Once you have achieved the best reception signal, press the
(green) button. The receiver will now
save these values for this satellite and skip automatically to the setting for the next satellite.
If you have selected more than one satellite for Tuner 1, the receiver will automatically skip to the settings
for the second satellite. Now de
fi
ne the settings for the second satellite, followed by the other selected
satellites, in the same way as described for the
fi
rst satellite.
Once all settings for all the satellites that you selected have been completed, the receiver will
automatically skip to the settings for the second tuner (assuming that for the second tuner you selected
the connection type “Separated” and set the signal con
fi
guration to “Different from Tuner 1”). If this is the
case, now de
fi
ne the settings for the second tuner in the same way as you did for the
fi
rst tuner.
Once you have completed the settings for both tuners and the satellites assigned to them, the receiver
will automatically display the screen for the channel search. Continue the
fi
rst installation with the
“Channel Search” section.
Connection and set-up
