111
Main menu - Settings
Remote control code
After calling up the menu, you will see the
following on-screen display:
You can use this function to allow
you to operate several receivers
(e.g. four UFS 925 units) using
the same remote control. You can
assign each receiver its own remote
control code. For this, it is essential
that the receiver was supplied
with the RC 670 remote control
(e.g. UFS 925) or with the RC 660
remote control (e.g. UFS 910).
You can now use the remote control for your receiver to set a new remote control code (the remote
control code 1 is set as standard). Press the following buttons simultaneously:
-
+
+
for remote control code 1
-
+
+
for remote control code 2
-
+
+
for remote control code 3
-
+
+
for remote control code 4
Now press the
button. If the receiver does not close the on-screen display, the receiver and the
remote control are not set to the same remote control code. Check your setting again.
To set the remote control for whichever remote control code is required in future, proceed as follows:
-
+
for remote control code 1
-
+
for remote control code 2
-
+
for remote control code 3
-
+
for remote control code 4
