Kathrein UFS 924, Руководство по эксплуатации

Страница: 47 / 64

47
Troubleshooting
In the event of a malfunction, fi rst check all the cable connections and operating states:
1. Receiver and TV set power plugs are connected to wall socket
2. Antenna cables are connected to the receiver input
3. Receiver and TV set correctly connected by a HDMI or Scart cable
4. Audio connections are made to Hi-Fi or Dolby Digital system as appropriate
5. Receiver and TV set (Hi-Fi/Dolby Digital system) are switched on (check power indicators)
6. Receiver is responding to remote control
A selection of troubleshooting tips is offered below.
Problem Cause Remedy
A “No signal!” warning
appears on some
or all channels
Consult an antenna specialist to have
it checked and repaired as necessary.
Check the settings made in the
“Settings”, “Antenna & Satellite”,
“Tuner Conf guration” menu, and
change them if necessary.
Receiver no longer
responds to the
remote control
The batteries may be f at or inserted
incorrectly in the battery compartment
Check the batteries (see also
“Inserting batteries into the remote
control” in the Operating Instructions
Part 1)
Receiver or remote control command
set may have been unintentionally
changed
Set infrared code 1 as described
in these operating instructions
under “Mainmenu settings”, “Basic
Settings”, “Setting the remote control
code”
Wrong time is displayed
“Summertime” setting wrong. An
incorrect time was imported from the
reception signal
Under “Settings”, “Basic Settings”,
“Time Setting” in the menu, check
the set time deviation to UTC and
change as necessary. Use the power
switch to switch the receiver of f from
the current channel, e.g. Das Erste
or ZDF, wait 10 seconds and then
switch it back on
The following channels
cut out or “No or bad
signal!” appears:
Sport 1, Tele 5, HSE 24
and Sonnenklar TV
DECT telephones operate on the
same frequency as these channels.
Interference may occur due to
inadequate output level or poor
shielding of cable
Consult your antenna specialist
Black or blue screen,
no on-screen displays
Scart connection to TV deactivated
by accidentally pressing the 0 button
Keep pressing 0 button until TV
picture reappears on-screen