Kathrein UFS 924, Руководство по эксплуатации

Страница: 11 / 64

11
If you want to operate your UFS 924 on a OneCable system, please refer to the
connection examples for OneCable systems (see “Technical appendix”, “Examples
of OneCable systems”)
This will only work when receiving one satellite, not in multifeed reception!
(Multifeed reception: simultaneous reception of several satellites)
To enable you to make full use of all the reception and recording features of your twin-DVR HDTV Sat
receiver, such as
1. recording one programme while viewing any other programme or channel zapping, and
2. recording two different programmes at the same time,
the two tuner inputs of the satellite receiver must each be supplied with a dedicated satellite signal from
the antenna system/Sat outlet (unless connected to a single-cable system).
The receiver tuner inputs are factory preset in the installation menu to work with two separate Sat antenna
connections.
In cases where only one antenna connection is available (with the exception of single-cable systems),
“Loopthrough” must be selected for “T uner 2 Connection type” in the “First Installation” settings (see the
section “First Installation”). Press the

button to access the “T uner Conf guration” menu option, then
select “Settings” and “First Installation”. Go through step by step until you get to the tuner con f guration.
You can def ne the settings here. Though a restriction on this is that with Tuner 2 you can only receive the
additional channels of the plane currently set by Tuner 1 (e.g. Horizontal High). From this point on only the
channels that can be selected are displayed in the channel list.
Information about antenna connection and loop-through mode
Connection and setup