Kathrein UFS 924, Руководство по эксплуатации

Страница: 15 / 64

15
Important instruction for picture
output using “YPbPr”:
The “YPbPr” outputs can only
be used if “RGB” is not selected as the
output signal for the TV Scart socket!
In this case, select “Y/C” or “CVBS” as the
output signal for the TV Scart socket.
You should perform the tuner confi guration/make changes yourself only if you are
fully familiar with the particulars of your reception system.
Press the

(green) button to move to the next menu.
The following on-screen display appears:
If your receiver is connected up as in the connection example (see the illustration in
“Connecting the receiver” in this section), only one change/selection is necessary in the rest
of the fi rst installation. If you are not familiar with the details of your reception system, note
the following:
In many cases the satellite reception system is a DiSEqC™1.0 system. This type of system is preset.
Confi rm the current on-screen displays using the

(green) button. Using the

buttons you
then select the required satellites in the satellite selection (in Germany usually ASTRA 19.2° East)
and confi rm your choice with the

button. Confi rm the rest of the on-screen displays during the
fi rst installation using the

(green) button. This process cannot damage your reception system!
If there is no TV picture at the end of the fi rst installation, contact your specialist dealer.
Connection and setup
Tip!