Kathrein UFS 900sw, Руководство по эксплуатации

Страница: 74 / 108

74
During the search you will see the
following on-screen display (example):
The newly found channels are identi fi ed
with the suf fi x “New” (see example
screenshot on the right).
Note:
You can cancel the search at any time
by pressing the

button.
Main Menu - Search Channels
you must repeat this procedure once for each satellite.
You can however start the fi rst installation again, in the course of which a channel search of all the
satellites you selected is performed.
Channel Search Mode
Use the

buttons to select the type of channels that are to be searched for. You have three
options:
- “free & scrambled” All channels are searched for
- “only free” Only free-to-air channels are searched for
- “only scrambled” Only encrypted channels are searched for
To view encrypted channels you need an appropriate CA (Conditional Access) module and a
valid smart card together with a valid subscription to the relevant Pay TV provider.
Network Search
Use the

buttons (On/Off) to select whether a network search should be performed. If you
set the network search to “Off”, only the factory stored transponders of the satellites you previously
selected will be searched for new as yet unlisted channels. If you set the network search to “On”, the
transponder network enables additional transponders that have not yet been stored to be located.
They are then stored and searched for new channels in the same way as the existing transponders.
Then use the

buttons to switch to the fi eld “Start Search”. Pressing the

button starts the
search.