Kathrein UFS 900sw, Руководство по эксплуатации

Страница: 21 / 108

21
Connection and setup
LNB Type
If your reception system does not have a Universal LNB, use the

buttons to select the
LNB types that are used in your reception system. You can choose from the following LNB types:
- Universal or
- Single
LNB Low Frequency
You only need to specify this data if your LNB type is not “Universal LNB”. For this, refer to the
documentation supplied with your LNB. Enter the LNB low frequency, using the numeric pad or
the

buttons.
LNB High Frequency
You only need to specify this data if your LNB type is not “Universal LNB”. For this, refer to the
documentation supplied with your LNB. Enter the LNB high frequency, using the numeric pad or
the

buttons.
22 kHz Signal
You only need to specify this data if your LNB type is “Single”. The 22 kHz signal is needed to
switch LNBs when using multi-feed reception and to switch between Low and High band. For this,
refer to the documentation supplied with your LNB.
LNB Power
This is factory-set to “On”, but must be changed of your LNB has its own power supply. In most cases
the LNB power supply is provided by the receiver.
Test transponder
To check whether the settings that you have made are correct, use the

buttons to move to
the “Test transponder” fi eld. Use the

buttons to select the required transponder from the
various ones listed. If your settings are correct, you will see at the top right of the screen the live signal
of a channel from the currently selected transponder.
If you do not receive a signal, check your settings again and if necessary call for expert help.
You have now completed all settings for the fi rst satellite. Press the

(green) button to return to the
“Satellite Selection Menu” and perform the settings in the same way for the remaining satellites.
When you have fi nished con fi guring the satellite, press the

(green) button. The receiver then
automatically calls up the selection menu for the channel search. Continue the fi rst installation by
selecting “Execute Channel search”.
LNB = Low Noise Block converter (feed system)