Kathrein UFD 515, Руководство по эксплуатации

Страница: 64 / 78

Setting system parameters
receiver to the receiving system for signal selection, are also
recognised by this system.
A remote frequency must not be set in this operating mode, because
it is defined by the
UFO micro system as part of the addressing
procedure.
You will need to delete the previously allocated address when using
the receiver for the first time together with a UFO
micro receiving
system. You can do this under the UFO micro menu point by selecting
"Reset" with the
-+
buttons and pressing
O
.
The original factory setting is then allocated to the receiver. It must
then be reset to ON. The receiver will then receive a new address
from the new system.
The pre-programming is not deleted with "Reset".
Presetting: OFF
Factory setting
Under this menu point, you can reset all the settings to the factory
setting by pressing
O
.
The factory settings need not necessarily correspond to the settings
required for your system!
After the reset, it may be necessary to repeat all settings.
64