Kathrein UFD 515, Руководство по эксплуатации

Страница: 56 / 78

Setting system parameters
Standby
Under this menu point the supply voltage for the LNB in receiver
standby mode can be switched on and off. It can be switched off for
individual and communal systems. The factory setting is "OFF."
Reception of 2 satellites.
If your receiver is connected to a multifeed antenna that is also
aligned with the HotBird satellites for instance, you will need to change
the receiver settings for the DiSEqC signal. The same, of course, also
applies to other satellites (DiSEqC = Digital Satellite Equipment
Control).
Different control signals are required for the purpose of selecting the
satellite signals. To date, the LNB supply voltages 14/18 V and the 22
kHz signal (superimposed on the LNB supply voltage) have been
sufficient for signal selection in the majority of applications. With these
four switching signals, it is possible to switch between horizontally and
vertically polarised signals as well as between satellites (multifeed
reception).
However, additional control signals are now required for LNB
activation and signal selection in view of the expansion of the
frequency range to 12 GHz (high-band range) and for receiving more
than two satellites.
The "DiSEqC" control signal is responsible for this task. This signal
represents a special modulation of the already existing 22 kHz signal.
DiSEqC setting
The precondition for this setting is that you have made no
changes in the DiSEqC (UFO) set-up, refer to the section
"DiSEqC (UFO) Set-up".
When you are in the LNB configuration menu (see above), press the
ou
buttons to move the coloured bar to the "HotBird" position,
press the
-
or
+
button and press
O
to confirm, that you wish to
add a satellite. The transponder data are now stored and a tick
appears after "HotBird" to confirm the setting. You can now set the
DiSEqC signal. It serves the purpose of switching between the two
aligned satellites. Press the
ou
buttons to go to the DiSEqC-1
setting.
Set #1 for ASTRA and #2 for HotBird. Both positions are already pre-
programmed. Both positions are already pre-programmed.
Press the
L
4 times to exit the menu. At the same time, the
receiver will confirm that the set parameters are saved. If a setting is
incorrect, you will see the following message on the screen:
With cascaded switches, a total of 16 satellite positions can be stored
under DiSEqC 2. With H/V as well as High/Low this results in a total of
256 settings. You should have a specialist carry out these settings
and set-up such a system.
Bad or no signal
56