Kathrein UFD 515, Руководство по эксплуатации

Страница: 17 / 78

First time installation
First time installation
The first steps
Connect the receiver to the mains power supply.
Switch on the receiver by pressing the power button on the front of the
unit.
The display, " - - - -,“ appears in the LED display.
When the LED for the operating display is red, the television is in
standby.
Switch on the receiver by pressing the
e
button on the remote
control.
The orange LED on the front panel of the receiver flashes every
time a button on the remote control is pressed.
You will see the factory set programme on your TV screen. An
information bar indicating the programme provider, the time, the timer
settings, the programme status and the programme title will be
displayed in the bottom section of the screen, provided the
corresponding data are transmitted. The number of the programme
memory appears in the LED display.
The red standby indicator goes out.
You can now receive the factory set TV and radio programme and
select it by pressing the
ou
buttons. Press the
R
and
ou
buttons to select radio programmes. Press the
R
or
T
button to return to TV programmes.
Refer to the section " Programme lists – TV/radio" for information on
how to set up and save other TV and radio programmes.
The reception status last set always reappears when the receiver
is switched on.
Please check the time of day for summer or winter.
If the message "bad or no signal" appears on the screen in addition to
an on-screen display indicating the programme last received, you will
need to check the system installation and/or the receiver settings. If
this problem only applies to individual programme slots, the problem
may be due to an interruption in the transmission signal or a fault in
the receiving system (cable or satellite system).
In this case, first check the connection configuration and then check
whether the basic settings of you receiver are correct for your system.
If necessary, have a specialist do this for you.
Factory setting of receiver
Your receiver is pre-programmed to receive the ASTRA and HotBird
satellites as well as 10E and 16E, TurkSat 42E, Telecom 5W and 8W.
You will normally not need to make further settings. If you are not
connected to a communal or party system, you need a multifeed
arrangement with at least two LNBs in front of the satellite dish, in
order to receive both satellite systems or other satellites. Please ask
your dealer.
Before you change the basic settings of your receiver, note down the
settings in the form provided at the end of this operating manual. You
will then be able to restore the original settings at any time.
17