English
63
d OK then lights up green and the manual burning pro-
cedure can be started
7.4.2 Automatic regeneration
몇
WARNING
Risk of burns
During the regeneration process, exhaust gases up to a
temperature of 600°C may be omitted.
Do not start the regeneration process in combustible are-
as.
Note
Work can continue during Automatic regeneration.
The automatic regeneration can be postponed in certain
situations.
7.5
Winter use
7.5.1 Frost protection
1. Check the frost protection of your vehicle. See chapter
"Maintenance work | Check coolant level and top up with
coolant ".
8
Attachments
Note
Please read the attachment operating instructions before
fitting an attachment.
Attachments are optional and can be attached to the in-
tended attachment points on the vehicle.
DANGER
Danger due to changed vehicle centre of gravity and
changed driving behaviour.
When transporting liquids and/or bulk material, such as
e.g. loose chippings, swirling movements can occur which
cause the vehicle to rock up and down.
In the case of conversions, especially when converting
from winter to summer operation, and with changed load-
ing conditions, the driver must adjust to a changed driving
behaviour.
몇
WARNING
Danger of crushing when mounting attachments
Do not reach between attachment points and the attach-
ment.
몇
CAUTION
Risk of burns from hot hydraulic couplings
Wear protective gloves when disconnecting the hydraulic
couplings.
ATTENTION
Wear suitable protective clothing, safety gloves and gloves
when installing and removing attachments. This also ap-
plies during usage and application.
Please contact your responsible dealer before fitting at-
tachments that are not specifically intended for this vehi-
cle. Your dealer will check if installation and use of these
attachments is permitted on your vehicle. This is important
for the safety of the driver and the vehicle and also for any
warranty claims.
Attachments that endanger the safety or stability of the ve-
hicle may not be used.
8.1
Coupling attachments to the vehicle
ATTENTION
Risk of damage
Keep hydraulic connections clean.
Clean the plug and coupling with a lint-free cloth before
use.
1
Coupling connector
2
Coupling sleeve
3
Ring
1. Pull the ring of the coupling sleeve downwards and hold.
2. Press the coupling connector of the attachment hydrau-
lic hose into the coupling sleeve.
3. Release the coupling ring. Check that it is securely en-
gaged.
4. To decouple, pull the ring downwards, hold it and pull
out the hydraulic hose.
8.2
Tow bar
Note
For permissible support load and trailer load, see chapter .
8.3
Ballasting the vehicle
Note
The front axle of the vehicle must always be loaded with at
least 30% of the net weight of the vehicle, and the rear axle
must always be loaded with at least 30% of the net weight
of the vehicle.
Before purchasing the attachment, check that these re-
quirements are met by weighing the vehicle-attachment
combination.
The following data is required for determining the total
weight, the axle loads, the tyre loading capacity and the re-
quired minimum ballast:
●
All weights in kg (weigh the vehicle if necessary)
●
All dimensions in meters (m)
TL (kg) = Net weight of the vehicle
*
TV (kg) = Front axle load of the empty vehicle
*
TH (kg) = Rear axle load of the empty vehicle
*
GH (kg) = Rear ballast total weight
**
Содержание MC 250
Страница 2: ......
