Page 92 of 101
DWG ID: 181-0101-00A
Date: 2003-09-26
This command specifies the character sent by the computer to the TALON to stop output
from the TALON. If set to $00 only hardware flow control will be used. For software
flow control set this parameter to the character the computer will send to stop data flow.
See also: start, xflow, xoff, xon
STREAMCA {ON | OFF}
default OFF
When receiving packets addressed only to you (MONITOR OFF and/or MCON OFF),
setting this command ON will enable the display of the callsign of the connected-to
station following the stream identifier of the connection (as controlled by STREAMEV).
This is especially useful when operating with multiple connections allowed.
See also: mcon, monitor, and streamev
STREAMEV {ON | OFF}
default OFF
When OFF, the stream indicator is displayed only when a change in streams occurs.
When ON, the stream indicator will be displayed with every incoming packet. This
command takes effect only when receiving those packets addressed to you and MCON is
OFF.
See also: mcon, monitor, streamca, and streamsw
STREAMSW n
(n = $00 - $FF)
default $7C (|)
This command selects the character to be used to signify that a new “stream” or
connection channel is being addressed. To change streams you must type this
streamswitch character followed immediately by the stream designator. The stream
designator is an alphabetic character A through Z, or a through z, limited by the value of
MAXUSERS.
If STREAMSW is set to the dollar sign ($24) you will need to enter parameter values in
decimal. Alternatively, precede the $ with the PASS character in order to enter hex
numbers.