Page 16 of 101
DWG ID: 181-0101-00A
Date: 2003-09-26
•
ONLY authorized personnel shall perform repair of Kantronics TALON UDC
products.
4.3
Information to the User
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
4.4
FCC Notice
It is the responsibility of the user of this equipment to obtain the proper FCC license to
operate this product on the desired channel of operation.
This product complies with part 15 of the FCC rules and regulations. It may not be
modified without the expressed consent of Kantronics. Modification of this product could
void the user’s authorization to use the product.
The user is cautioned that any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
The user is also cautioned that any peripheral device installed with this equipment must
be connected with a high-quality shielded cable to insure compliance with FCC limits.
Note:
The shield of the cable, whether foil, braid, braid over foil, or double braid, must
be properly terminated (connected) 360
°
to the connector. This is usually accomplished
by the use of a metal or metalized plastic back shell, but may be implemented by direct
contact, including soldering, with metal portion of connector. Experience has indicated
that cable assemblies (with connectors) advertised as “shielded” are not necessarily
terminated properly, if terminated at all. Check cable construction to be sure.
4.5
Industry Canada Notice
This Class A digital apparatus meets all requirements of the Canadian Interference
Causing Equipment Regulations. Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may
cause undesired operation.