Kanga 216 Series, Руководство оператора

Страница: 79 / 100

© 2022 Kanga Loaders.
75
Series 216 Loader
Drive System (continued)
TROUBLE PROBABLE CAUSE REMEDY
Machine drive speed is
erratic.
Hydraulic system oil low.
Check oil and replenish as necessary. Oil level
should not change. Leaks may be present.
Damaged or blocked line.
Remove line and remove any obstructions or replace
line as necessary.
Binding drive motor(s). Repair or replace motor(s) as necessary.
Relief valve setting. Adjust relief valve.
Auxiliary Hydraulic
TROUBLE PROBABLE CAUSE REMEDY
Attachment is slow or
will not function.
Hydraulic system oil low.
Check oil and replenish as necessary. Oil level
should not change. Leaks may be present.
Damaged or blocked line.
Remove line and remove any obstructions or replace
line as necessary.
Malfunctioning pump. Replace hydraulic pump as necessary.
Worn control valve spool.
Check pressure delivery from control valve. Repair or
replace valve as required.
Attachment plate pivot pin seized or
otherwise damaged.
Replace pivot pin and bushing as necessary. Grease
thoroughly.
Excessive oil leak past cylinder piston seal
or motor rotating group.
Repair or replace cylinder motor as necessary.
Control rod or lever broken or disconnected. Repair or replace control rod or lever.
Engine
TROUBLE PROBABLE CAUSE REMEDY
Engine will not crank
over.
Low battery output. Recharge or replace battery.
Loose, disconnected or broken battery
cables.
Inspect cable(s) and tighten all connections. Repair
or replace cables as necessary.
Faulty starter. Repair or replace starter.
Faulty circuit wiring. Check wiring continuity.
Engine flooded (gasoline engines). Remove spark plug and crank.
Engine cranks but does
not fire.
No fuel in tank. Refill fuel tank.
Spark plug fouled (gasoline engines).
Check spark plug gap and clean or replace spark
plug.
Dirty fuel filter. Clean or replace filter.
Carburettor flood (gasoline engines). Clear carburettor.
Fuel valve closed. Open valve.
Engine runs but stalls.
Spark plug fouled (gasoline engines). Check spark plug gap and clean or replace.
Fuel valve closed. Open valve.
Low battery output. Recharge or replace battery.
Power take-off engaged. Shift power take-off lever into neutral.
Operator’s Manual · Troubleshooting Guide