Kanga 216 Series, Руководство оператора

Страница: 47 / 100

© 2022 Kanga Loaders.
47
Series 216 Loader
Installation
1. Position the wheels with air valves in the same
orientation (C) .This will assist in aligning the
wheels to the studs. Lay wheels and tracks flat
on the floor.
2. Attach the left and right end segments of the
installation tool to each wheel (D) .
3. Slide the guide through both segments (E) .
4. Install the scissor jack with handle end pointing
through the top of the track ( F ).
5. Tension the jack to extend the track assembly.
Stand the track upright.
6. Working with another person, lift the tracks
onto hub spigot. Adjust the jack as needed.
7. Rotate the rear hub using an adjustable
wrench. Align the studs with the wheel while
depressing forward/reverse control lever (G) .
Do not start the engine.
8. Locate the rear wheel on the hub and studs.
Place one wheel nut to hold the wheel to the
hub.
9. Rotate the front hub using an adjustable
wrench. Align the studs to the wheel while
depressing forward/reverse control lever.
Do not start the engine.
Note
To do this, the jack may have to be extended or
retracted. If the tracks cannot be extended far
enough using the scissor jack, reduce the tire
pressure and extend the scissor jack further.
10. Install all wheel nuts and tighten to 135Nm
(100 ft-lb).
11. Reinflate tires to between 55 PSI (379 KPA)
and 75 PSI (517 KPA). Refer to the tire pressure
section for further information.
C
D
E
G
F
Operator’s Manual · Install Track