Kanga 216 Series, Руководство оператора

Страница: 65 / 100

© 2022 Kanga Loaders.
61
Series 216 Loader
1. Overcenter Valve
Connect an accurate pressure gauge with a range
0 – 300 bar (0 – 4300 PSI) to the test point. The
pressure should be set at 34 – 41 bar (500 – 600
PSI) for the 11.3 cc pump.
If adjustment is required, slacken off the locknut.
Using a 5mm hex key, wind the screw in to increase
the pressure or out to reduce the pressure. Re-
tighten the locknut when adjustments are complete.
2. Main System Relief Pressure
Connect an accurate pressure gauge with a range 0
– 300 bar (0 – 4300 PSI) to the test point. Check the
pressure while pulling the tilt control lever at the end
of the ram’s stroke. The pressure should be set at
207 bar (3000 PSI) for gasoline models and 220 bar
(3200 PSI) for diesel models.
If adjustment is necessary, slacken off the locknut
on the main pressure relief valve. Wind the screw
in to increase the pressure or back off the screw to
reduce the pressure. Re-tighten the locknut when
adjustments are complete.
3. Lift Pressure
Connect an accurate pressure gauge with a range
0 – 300 bar (0 – 4300 PSI) to the test point. With the
boom fully raised, check the pressure while pulling
the arm control lever at the end of the ram’s stroke.
The pressure should be set at 165 bar (2400 PSI) for
mid-range loaders.
If adjustment is necessary, unscrew the cap locknut
on the lift pressure relief cartridge. Using an Allen
key, wind the screw in to increase the pressure or
back off the screw to reduce the pressure. Refit and
tighten the locknut when adjustments are complete.
Hydraulic Fluid
Replace the hydraulic oil after every 1,000 operating
Plug
hours, using Hydraulic Oil ISO 68.
Hydraulic Oil
The viscosity of an oil is identified by its “ISO
Viscosity Rating” The ISO viscosity rating can be
found on the oil container’s label.
OIL VISCOSITY
AMBIENT
TEMPERATURE
CELSIUS
AMBIENT
TEMPERATURE
FAHRENHEIT
ISO 46
A medium weight oil for
mid-range conditions
with local temperatures
ranges
-4° to +21°C +25° to +70°F
ISO 68
A heavier oil
for warm weather
conditions with local
temperature ranges
+4° to +32°C +40° to +90°F
The Kanga hydraulic system operates at a oil
temperature between 60 - 80°C (140 - 176°F). Using
a hydraulic oil that meets these requirements will help
eliminate costly machine downtime and reduce the
overall operating cost of your equipment. Failure to
use the correct hydraulic oil could create problems
and cost you time and money.
Kanga Recommends
For Australian conditions ISO 68
For colder American & European conditions ISO 46
IMPORTANT:
Check with your supplier before mixing hydraulic oils
of different type, brand, or viscosity. Many oils are
not compatible and damage to your hydraulic system
could result. When changing oil viscosity, flush and
clean the hydraulic system before adding new oil.
Hydraulic Oil Drain Plug
The hydraulic oil drain plug is located on the
front side of the loader.
Operator’s Manual · Perform Service Tasks
Test Point