Kanga 216 Series, Руководство оператора

Страница: 64 / 100

60
Series 216 Loader
© 2022 Kanga Loaders.
Service Tasks: Hydraulics
(continued)
Hydraulic Pressure Settings
The hydraulic system has three pressure settings.
These are referred to as the overcenter valve, the
main system relief pressure, and the lift pressure.
Before any testing is carried out, run the engine
and hydraulic system to warm the hydraulic oil. The
oil cooler fan will engage at between 60 and 65°C
(~145°F).
The pressure settings must be set as follows:
Note
All pressure settings are performed with the oil cooler fan
on and engine running at full speed (3,600 rpm).
Service Tasks: Hydraulics
Hydraulics
Perform the following work after every 100
operating hours:
With arms down and oil cold, check hydraulic fluid
level. The hydraulic oil should be visible half way
(50%) down the sight gauge when the oil is cold
and all rams in their closed position. Top up with
Hydraulic oil ISO 68 if necessary.
Note
A significant drop in fluid levels indicates leakage. The
appropriate cold fluid level is shown on the sight gauge.
Inspect all hydraulic hoses, tubes, fittings, valves,
and rams for leaks and damage. Tighten loose
fittings and replace damaged components.
Check all three pressure settings every 200 hours
and adjust if necessary.
Hydraulic Filter
Replace the return line filter cartridge after every
200 operating hours.
Pressure Filter
Replace inline filter cartridge after every 500
operating hours.
PRESSURE FILTER ELEMENT
Part Number KA-000400
(Illustration shows housing.)
Operator’s Manual · Perform Service Tasks
Location of filler
RETURN FILTER ELEMENT
Part Number KA-000400
(Illustration shows housing)
Hydraulic oil filler gauge Hydraulic oil filler gauge
Overcenter valve
Main system
relief
Lift pressure