Kaden KS09, Руководство по установке

Страница: 18 / 36

18 | Kaden Installation Manual
Take note of fuse specifications
The air conditioner’s circuit board (PCB) is designed with a
fuse to provide overcurrent protection. The specifications
of the fuse are printed on the circuit board, such as:
T3.15A/250VAC, T5A/250VAC, etc.
1. Prepare the cable for connection:
a. Using wire strippers, strip the insulation from both ends
of signal cable to reveal about 40mm (1.57in) of the wires
inside.
b. Strip the insulation from the ends of the wires.
c. Using wire crimper, crimp u-type lugs on the ends of the
wires.
2. Open front panel of the indoor unit by loosening the screws
according to picture Fig. 3.13, which provide space for
wiring connection.
3. Open the terminal cover to connect the cable.
Terminal
block
Wire
cover
Cable
clamp
Fig. 3.13
The Wiring Diagram is located
on the inside of the indoor unit’s
wire cover.
WARNING
All wiring must be performed strictly in accordance
with the wiring diagram located on the inside of the
indoor unit ’s terminal cover.
Note about wiring
The wiring connection process may differ
slightly between units.
4. Unscrew the cable clamp below the terminal block and
place it to the side.
5. Facing the back of the unit, remove the plastic panel on the
bottom left-hand side.
6. Feed the signal wire through this slot, from the back of the
unit to the front.
7. Facing the front of the unit, match the wire colors with the
labels on the terminal block, connect the u-lug and firmly
screw each wire to its corresponding terminal.
8. After checking to make sure every connection is secure, use
the cable clamp to fasten the signal cable to the unit. Screw
the cable clamp down tightly.
9. Replace the wire cover on the front of the unit, and the
plastic panel on the back.
J3387_Kaden_Installer_Manual_050917.indd 18 5/09/2017 9:08 AM