Kaden KS09, Руководство по установке

Страница: 15 / 36

Kaden Installation Manual | 15
3. Use the holder in the mounting plate to prop up the unit,
giving you enough room to connect the refrigerant
piping, signal cable, and drain hose.
Fig. 3.6
Fig. 3.7
Step 4
Keep pipe connection point exposed to perform the leak
test (refer to
Electrical Checks and Leak Checks section
of this manual).
Step 5
After the leak test, wrap the connection point with
insulation tape.
Step 6
Remove the bracket or wedge that is propping with
insulation tape.
Step 7
Using even pressure, push down on the bottom half of the unit.
Keep pushing down until the unit snaps onto the hooks along
the bottom of the mounting plate.
If there is no refrigerant piping embedded in the wall,
do the following:
1. Based on the position of the wall hole relative to the
mounting plate, choose the side from which the piping
will exit the unit.
2. If the wall hole is behind the unit, keep the knock-out panel
in place. If the wall hole is to the side of the indoor unit,
remove the plastic knock-out panel from that side of the
unit. (See Fig. 3.8). This will create a slot through which your
piping can exit the unit. Use needle nose pliers if the plastic
panel is too difficult to remove by hand.
Knock-out Panel
Fig. 3.8
3. Use scissors to cut down the length of the insulating sleeve
to reveal about 40mm (1.57in) of the refrigerant piping.
This serves two purposes:
• To facilitate the Refrigerant Piping
Connection
process.
• To facilitate Gas Leak Checks and enable
you to check for dents
Step 3
Connect drain hose and refrigerant piping (refer to Refrigerant
Piping Connection
section of this manual for instructions).
Fig. 3.7
Fig. 3.6
Fig. 3.8
J3387_Kaden_Installer_Manual_050917.indd 15 5/09/2017 9:08 AM