Kaden KS09, Руководство по установке

Страница: 12 / 36

12 | Kaden Installation Manual
Step 2: Attach mounting
plate to wall
The mounting plate is the device on which you will mount the
indoor unit.
1. Remove the screw that attaches the mounting plate to the
back of the indoor unit.
2. Place the mounting plate against the wall in a location that
meets the standards in the Select Installation Location
step. (See Mounting Plate Dimensions for detailed
information on mounting plate sizes.)
3. Drill holes for mounting screws in places that:
• have studs and can support the weight of the unit
• correspond to screw holes in the mounting plate
4. Secure the mounting plate to the wall with the
screws provided.
5. Make sure that mounting plate is flat
against the wall.
Step 3: Drill wall hole for
connective piping
You must drill a hole in the wall for refrigerant piping, the
drainage pipe, and the signal cable that will connect the
indoor and outdoor units.
1. Determine the location of the wall hole based on the
position of the mounting plate. Refer to Mounting Plate
Dimensions on the next page to help you determine the
optimal position. The wall hole should have a 65mm (2.5in)
diameter at least, and at a slightly lower angle to
facilitate drainage.
2. Using a 65mm (2.5in) or 90mm(3.54in) (depending on
models) core drill, drill a hole in the wall. Make sure that
the hole is drilled at a slight downward angle, so that the
outdoor end of the hole is lower than the indoor end by
about 5mm to 7mm (0.2-0.275in). This will ensure proper
water drainage. (See Fig. 3.2)
3. Place the protective wall cuff in the hole. This protects the
edges of the hole and will help seal it when you finish the
installation process.
Refer to the following
diagram to ensure
proper distance from
walls and ceiling:
Note for concrete or brick walls
If the wall is made of brick, concrete, or similar material,
drill 5mm-diameter (0.2in-diameter) holes in the wall and
insert the sleeve anchors provided. Then secure the
mounting plate to the wall by tightening the screws
directly into the clip anchors.
CAUTION
When drilling the wall hole, make sure to avoid wires,
plumbing, and other sensitive components.
Fig. 3.1-b
12cm (4.75in)
or more
2.3m (90.55in) or more
12cm (4.75in)
or more
15cm (5.9in) or more
J3387_Kaden_Installer_Manual_050917.indd 12 5/09/2017 9:08 AM