Kaden KS09, Руководство по установке

Страница: 11 / 36

Kaden Installation Manual | 11
5. Indoor Unit Installation
Note about wall hole
If there is no fixed refrigerant piping:
While choosing a location, be aware that you should
leave ample room for a wall hole (see
Drill wall hole for
connective piping step) for the signal and power cable
and refrigerant piping that connect the indoor and outdoor
units. The default position for all piping is the right side of
the indoor unit (while facing the unit).
However, the unit can accommodate piping to
both the left and right.
Step 1: Select installation location
Before installing the indoor unit, you must choose an
appropriate location. The following are standards that will
help you choose an appropriate location for the unit.
Proper installation locations meet
the following standards:
Good air circulation
Convenient drainage
Noise from the unit will not disturb other people
Firm and solid—the location will not vibrate
Strong enough to support the weight of the unit
A location at least one meter from all other electrical
devices (e.g., TV, radio, computer)
DO NOT install unit in the
following locations:
Near any source of heat, steam, or combustible gas
Near flammable items such as curtains or clothing
Near any obstacle that might block air circulation
Near the doorway
In a location subject to direct sunlight
Prior to installation
Before installing the indoor unit, refer to the label on the
product box to make sure that the model number of the
indoor unit matches the model number of the outdoor unit.
Fig. 3.1-a
Installation instructions –
Indoor unit
J3387_Kaden_Installer_Manual_050917.indd 11 5/09/2017 9:08 AM