Kaco blueplanet 110 TL3, Руководство пользователя

Страница: 50 / 119

Country-
spec. Set-
tings Level Display/
settings
Action in this menu/meaning
4 1
2
3 4
Insulation resistance
100 – 2000 [kOhm] /
300 [kOhm] /
1[kOhm]
1. Set threshold value at which the insulation monitor reports a fault.
2. Confirm the action field.
4
1
2 3 4
Grid Parameters Input screens for network parameters
4 1
2
3 4
Country & Grid type
NOTE: This option influences the country-specific operating
settings of the device. Please consult KACO service for further
information.
1. Select country and grid type.
2. Observe the note for [See section 9.4.2
}
Page 69]
Nominal grid voltage &
Nominal grid frequency
Password protection
Status
F Specify optional nominal grid voltage.
NOTE: The device switches off if the grid frequency deviates
from the nominal grid voltage by more than 9.5Hz.
1. Select optional nominal grid frequency.
2. Activate optional password protection.
3. Activate optional password protection.
4 1
2
3 4
FRT (Fault Ride
Through)
NOTE: The device supports dynamic grid stabilization (Fault
Ride-Through).NOTICE! More detailed information at
[See sec-
tion 10.3
}
Page 88]
4 1 2 3 4
Operating mode –
On | Off
F Select a control process.
On : Activates dynamic grid support using dynamic reactive current.
Off : Deactivates dynamic grid support using dynamic reactive current.
Dynamic grid support remains active on account of immunity to inter-
ference.
Setting | Manual |Pre-
defined zero current F Select a control process.
Priority – Reactive cur-
rent limitation | Active
current priority F Select a control process.
4 1 2 3 4
Constant k positive se-
quence dip &
Constant k positive se-
quence swell
k 0 – 10 2 0.1
F Set amplification factor k for the pos. sequence for drop and increase
in the grid voltage.
4
1 2 3
4
Constant k negative se-
quence dip
Constant k negative se-
quence swell
k 0 – 10 2 0.1
F Set amplification factor k for the neg. sequence for drop and increase
in the grid voltage.
4 1 2 3 4
Dead band
2 – 120 [% Uref]
10.0 0.1
F
Set dead band in %.
9 | Configuration and operation Manual
KACO blueplanet 110 TL3 KACO blueplanet 125 TL3 Page 50
EN-US